Welcome everyone to the TFB Armorer’s Bench! As mentioned in the little blurb below, this series will focus on a lot of home armorer and gunsmith activities. In this article, I am going to relay my experience threading a barrel without a lathe. More specifically [Read More…]
That sharp, corkscrew section on the end of your barrel is called the ‘threads’. And it is completely ok to admit that is where your level of knowledge on barrel threading ends (until recently, I was right there with you). For those of us who run stock [Read More…]
Iraqveteran8888 put up a video of Ryan threading a Mosin Nagant barrel using a power drill and a special bit that is cutting the shoulder. The bit has a pilot guide rod that helps keep the bit centered on the barrel. After cutting the shoulder Ryan can thread the barrel [Read More…]
Your Privacy Choices