1800’s Cartridge Rifle Showdown: Hands-on Firepower Analysis of Sharps, Spencer, and Henry

    Henry Vs Spencer Vs Sharps

    Henry Vs Spencer Vs Sharps

    During the latter years of the American Civil War and Indian Wars, the technological revolution in cartridge firearms played out in the battlefields of America.  Single-shot metallic cartridge firearms represented a massive increase in firepower and efficiency over loose powder.  Shortly thereafter, repeating metallic cartridge firearms gave the individual even more volume of fire.

    Having on hand an example of three more prolific metallic cartridge firearms of the latter half of the 19th century, I decided to make a hands-on experiment on roughly how much more firepower one could get with each system.  For the purposes of this piece, “firepower” refers to rapid, though aimed fire at a man-sized target 75 yards away, quantified in both time and accuracy.

    On its face, the concept of this hands-on experiment might cause one familiar with the Sharps, Spencer, and Henry to draw an instant conclusion that the Henry would obviously be the winner and the Sharps the loser.  That is, indeed, true.  However, I was curious about roughly how much the disparity of each system would be.

    Firearms and Course of Fire

    There were two courses of fire for each firearm: 5 rounds from standing at 75 yards, and 5 rounds from prone at 75 yards.  A clear sight picture would be required for each shot, as aimed rapid fire is one of the focus points of this experiment.  The firearms used were as follows:



    Sharps .45-70 33″ Barrel

    • Manufacturer: Cimarron
    • Single shot.
    • Manual of arms: Swing down lever to eject fired cartridge, manually insert fresh cartridge, swing up lever, cock hammer, fire.
    Spencer Carbine

    Spencer Carbine

    Spencer Carbine .45 Colt 20″ Barrel

    • Manufacturer: Cimarron
    • Lever action, manually cocked repeater.
    • Manual of arms: Swing down lever to eject fired cartridge, swing up lever to chamber cartridge, cock hammer, fire.
    Henry Carbine

    Henry Carbine

    Henry H006S .45 Colt 20″ Barrel (Not an original 1860 “Henry”, but a stand-in for most lever-action cartridge repeaters of the later 1800s)

    • Manufacturer: Henry Repeating Arms
    • Lever action repeater.
    • Manual of arms: Swing down lever to cock hammer and eject fired cartridge, swing up lever to chamber cartridge, fire.

    As we can see by the manual of arms for each system, the Sharps has five steps to firing, the Spencer four, and the Henry three.

    Performance and results:

    On a hot, dusty late summer day in the high desert of the American West, I conducted the experiment.  Though I’ve had plenty of trigger time with each gun, I fired two practice strings with each firearm before going for a final string.  It was good fun to blast away with Black Hills’ 405gr .45-70 and 250gr .45 Colt Cowboy Action loads, and when the smoke and dust cleared, results were as follows, measured in seconds.  Anything outside of the C zone of an IPSC silhouette counted as a “miss”:

    Sharps Rifle (Reloaded from a leather cartridge belt):


    • Fast Split (time between shots): 7.7
    • Slow Split: 9.8
    • Total: 36.25
    • 2 misses


    • Fast Split: 7.48 seconds
    • Slow Split: 9.82 seconds
    • Total: 34.34 seconds
    • 0 misses

    Spencer Carbine:


    • Fast Split: 4.57
    • Slow Split: 7.3
    • Total: 21.28
    • 2 Misses


    • Fast Split: 4.55
    • Slow Split: 5.4
    • Total: 20.37
    • 0 misses

    Henry Carbine:


    • Fast Split: 1.58
    • Slow Split: 1.6
    • Total: 6.76
    • 0 misses


    • Fast Split: 1.42
    • Slow Split: 1.79
    • Total: 6.5
    • 0 Misses
    Spencer Carbine

    Spencer Carbine

    A Sharper Understanding

    A cursory look at the results reveals that changing from manually loading from a cartridge box or belt (Sharps) to mechanical loading from a tubular magazine (Spencer) yielded an average improvement of roughly 41.43%.

    Changing from having to manually cock the hammer (Sharps and Spencer) to mechanical cocking of the hammer and being able to keep one’s firing hand purely on the lever (Henry) yielded an average improvement of roughly 68.3% when one compares the Henry to the Spencer, and a whopping 81.43% when comparing the Henry to the Sharps!

    The Henry was also far easier to acquire and keep a clear sight picture with both standing and prone.  This yielded not only better speed, but better accuracy when pressed into rapid-fire.  Though the Sharps would be better for slow, carefully aimed fired at range, it pales in comparison to the Henry when used in a close-range rapid-fire situation, especially if one needed to aim at moving targets.

    Let’s look at an example of a force armed with a single shot like the Sharps, Remington Rolling Block or an 1873 Trapdoor versus a lever-action repeater such as the Henry.  If each individual could fire 5 rounds 81.43% faster than their opponent in battle, it’s a real eye-opener to see just how much more “firepower” the force armed with the mechanical repeaters would have.

    For me, it lent a concrete experience to how John T. Wilder’s lighting brigade could have outmatched their opponents, how outmatched Custer’s 7th would have been against the Sioux, or how lever actions helped the Turks delay Russian and Romanian forces during the Plevna siege of 1877.

    Rusty S.

    Having always had a passion for firearms, Rusty S. has had experience in gunsmithing, firearms retail, hunting, competitive shooting, range construction, as an IDPA certified range safety officer and a certified instructor. He has received military, law enforcement, and private training in the use of firearms. Editor at Outdoorhub.com