Strike Industries has launched two new products, a pistol grip and a selector switch, designed for the CZ Scorpion EVO 3. Both of the new parts are compatible with all CZ Scorpion EVO 3 models. Let’s see what features each of the new parts packs.
Compared to the factory CZ grip, the new SI pistol grip has a closer-to-vertical 15-degree angle. The grip is made of polymer and has textured front and back straps. The company notes that the smooth sides of the grip can be stippled. This grip also features a beavertail extension and has an internal compartment covered by a rubber cap. The overall weight of the new grip is 3.1 oz and it has the following dimensions: length – 77.55mm (3.05″), width – 31.7mm (1.25″), height – 125.45mm (4.94″). The new SI CZ Scorpion grip is a drop-in product and comes with the set screw, Allen key and thread locker necessary to install it.
The Strike Industries CZ Scorpion EVO selector switch is also made of polymer and is a drop-in upgrade, too. The package includes the three pieces shown above that allow assembling both ambidextrous and non-ambidextrous safety selector configurations. Obviously, the part that lacks a lever must be installed on the side of the gun where you don’t want to have a selector. The wide serrated levers should be easy to reach and manipulate. The dimensions of the selector switch are as follows: length – 24.5mm (.96″), width – 16.9mm (.66″), height – 14.95mm (.59″). This product also comes with all the hardware and tools necessary for installation.
If you are an owner of a CZ Scorpion EVO 3, tell us in the comments what do you think about these new SI products. Do you think they will provide significant ergonomic improvements over the factory parts or do you find the factory grip and selector good enough?
Images by Strike Industries, www.strikeindustries.com